Set the #1 sample rate to match what you setup in the CW Skimmer settings panel.Do not send callsigns without CQ → user preference, but usually not selected.Port → set to desired port or use the default port 7310.All other settings use the default values.Audio I/O Device → to match your system's Play Back Audio Device.CW Pitch → to match the CW Pitch frequency in the SmartSDR CW panel.Lo Frequency → This is automatically set by DDUtil.Sample Rate → to match DAX IQ Stream in the DAX control panel for slice A.When CW Skimmer starts for the first time from DDUtil, open the Settings pane and configure the following tabs.Select the WinWarbler check box if you want WinWarbler's Call window to be populated with the Band Map call sign if the call sign is clicked.Select the QSY VFO B check box if you want VFO B to QSY when a CWS Waterfall trace or a call is clicked in CW Skimmer.Not selecting this check box will cause CW Skimmer to be minimized when the Enable check box is un-selected or when DDUtil closes.Select the Skimmer Close check box if you want CW Skimmer to close when the Enable check box is un-selected or when DDUtil closes.In the window next to the Enable check box select the TCP/IP port to be used to communicate with CW Skimmer (default is 7310).In the CW Skimmer group on the Features tab.You must own a registered copy of CW Skimmer (v1.83 or later) which can be obtained from the DX Atlas web site.Optionally, the call sign can be sent to DXLab's WinWarbler when a CWS waterfall or band map is clicked.
Optionally, VFO B can be set from a CWS waterfall or band map click.This feature only works with Slices A/B.This feature only supports F6000 radios.Connection is accomplished using TCP/IP and special Telnet commands. This implementation loads and connects SmartSDR to CW Skimmer without using a virtual serial port pair.
0 kommentar(er)
